Type lengths as 600, 23.75, 23 3/4, 23-3/4, or 4' 6 1/2". A unit after a number (mm, cm, m, in, ft) overrides the one chosen here.
Each row is a name, then width × length, quantity, and grain.
Width is the short side and length the long side. Grain, when ticked, runs along the length. Leave quantity empty for as many sheets as needed. Standard sizes are nominal, so measure your own stock; MDF and melamine are often sold slightly oversize.
Each row is a name, then width × length, quantity, and grain.
A part with grain ticked keeps its length along the grain of the sheet, so it is never turned. Parts without it may be turned 90 degrees when that saves material.
Working out the layout.
Kerf values in the list are typical. Measure the slot your own blade leaves in a test cut. Edge trim is the distance from each factory edge to the clean edge you keep, and the trimming cut's kerf falls inside it.
Cuts for the sheet in the preview, in order. Point at a row to find the cut on the drawing. The fence is the distance from the edge of the piece being cut to the near side of the blade.
Enter the stock sheets you have and the parts you need, and the layout shows how to cut them from the fewest sheets. Tools like this are also called cut list optimizers, sheet cutting calculators, or panel layout planners.